Erector 5 hole strip watch online
The set screws now only have to transfer the rotational motion from the inch drive axle.
The addition of an MF 1-inch x 5-inch base plate across the upper left end compare Figure 2 in the manual with Photo 1 between the angle girder and the inch base plate will allow the four brace girders to be attached at 90 deg.
At this point, I attached the top cone section to the outer top ring of the carousel, and set the main body of the carousel onto the inch drive axle.
It may even bring a new lease of life to worn out motors of run those safely where the mains lead is frayed or worn and saves the cost or replacing it.
The use of a CR special turret plate with hub in place of a non-existent fifth pierced disc, see note 9 would work but these spacers are themselves an addition to the contents of the Amusement Park set.
Remember this when setting up the drive gears.
Two causes were found.
Dave Ware writes To keep a string drive belt from slipping, tie the loop with it only around one pulley and around the axle of the other pulley.